BAT-BOX
Wall mounting cabinet for batteries housing
Max 2 batteries 12Vdc 7,2A/h
Dim 200x200x100mm
SC-8
Relay Card
N. 8 SPDT 24Vdc maximum switchabe current 8A@30V
Relays status LED indicators
Protection fuse on output contacts
Connections by exctractable pin terminals or 50 pins Flat Cable
M-20 PIN TERMINAL
Screw pin terminals assembled on circuit for cards for DIN rail mounting for the electrical connection between the sensors in the fiield and BUS-10 cards
BUS-10
Interconnecting card for acquisition modular systems that use REL/isp modules.
Each BUS-10 card can manage up to max 10 REL/isp units, the interconnection is made in a very practical and sure mode using stress tested connectors for multi polar cable like 20 pins ribbon.
The Hardware extreme modularity allows a wide range of installation solutions, allowing to be suitable in every electrical panel or in existing systems.
CM-PWS
Board for power distribution, battery charge control and ventilation system management
Ti potrebbe interessare…
PWS CNT
Card for power supply distribution, batteries charge control and ventilation system managing.
Managing of redundant power supply with hot back up (optional)
Led indications for all operating conditions, fuse status and net presence
Indication for correct grounding and batteries status
Ti potrebbe interessare…
JB-485 JUNCTION BOX
Plastic or aluminium alloy junction box complete with internal pin terminal for the distribution of the signal RS-485 and power supply.
Also available with driver for regeneration of RS-485 signal.
Ti potrebbe interessare…
BOX 19
Wall mounting 19″ cabinet with openable front door and window, openable sides for inspections/connections, complete with thermostated ventilation system.
CM-PWS board for power distribution and batteries monitoring.
Power 220Vac 250W Output 24Vdc, 10,4A
Ti potrebbe interessare…
REM-485-T3
I/O expansion module
n.2 RS-485 serial ports
No. 2 opto isolated digital inputs
No. 6 programmable relays outputs
No. 8 4-20mA analogue inputs
Modbus RTU communication protocol
Optical fiber Driver (Optional CM80-ID/O)
Power supply 24Vdc
Open frame version for DIN rail mounting
Ti potrebbe interessare…
REM-485-T2
4-20mA analogue inputs expansion module.
N. 8 inputs overload protected with remote reset funcion for manual reset sensors.
Seria Bus with Modbus RTU protocol connection to the central unit
Power supply 24Vdc.
Open frame version for DIN rail mounting.
